Table of Contents
Advertisement
STEERING WHEEL CONTROLS
B
Turn Signals
To operate:
Move lever up/down for right/left turn signal
§
Slightly move lever up/down to activate one-touch lane
§
change signal
Windshield Wipers & Washers
To operate:
Move lever up/down to change wiper modes
§
MIST: Single wipe
OFF: Wiper off
AUTO: Auto Rain Sensing
Pull to spray and wipe
§
Auto Rain Sensing
The rain sensor located on the upper end of the windshield
glass is designed to sense the amount of rainfall and
control the wiping cycle for the proper interval. The more it
rains, the faster the wiper operates. When the rain stops,
the wiper stops.
To turn ON the auto rain sensing wipers, move lever up/
down to AUTO. To adjust the auto rain sensing wiper speed
setting, move the speed control switch
Lifting Wipers (Wiper Service Mode)
To lift the windshield wipers to clean windshield, inspect or
replace wiper blades or raise wipers in snow/ice conditions
to prevent damaging the hood, the blades need to be moved
to the service position
With the ignition ON, then turning the ignition OFF, within
20 seconds move the wiper switch to the MIST position
and hold the switch for more than two seconds until the
wiper blade is in the fully up position.
To return wipers to normal position, turn the ignition ON,
then activate MIST.
ALWAYS CHECK THE OWNER'S MANUAL FOR COMPLETE
OPERATING INFORMATION AND SAFETY WARNINGS.
A
LO: Slow wipe
HI: Fast wipe
A
up/down.
.
C
MIST: Single wipe
OFF: Wiper off
AUTO: Auto Rain Sensing/Intermittent wipe
LO: Slow wipe
HI: Fast wipe
REMINDERS:
One-touch lane change signal is activated by briefly
§
pressing the turn signal lever slightly for less than 1
second and then releasing. The lane change signal
will blink 3 times
To change how many times the lane change signal
§
blinks (3/5/7), go to User Settings in the LCD
instrument cluster modes
WIPER SERVICE MODE
VIDEO
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to page 2 for
more information.
Quick Tips
When the Engine Start/Stop button is in the ON
§
position and the wiper switch is in AUTO mode, the
wiper will automatically operate once to perform a
self-check of the system
Set the wiper to the OFF position when the wiper
§
is not in use
If going through a car wash, remind the attendant
§
to keep the vehicle in Neutral (N) and keep the
engine running. Also, disable the Smart Power
Trunk lid control, turn off the auto rain sensing
wipers and fold in the mirrors
Moving lever to HI increases intermittent wipe
§
frequency and wipe speed. Moving lever to LO
decreases frequency of wipes
§
Pressing button
frequency and wipe speed. Pressing button down
decreases frequency of wipes
B
For more information on the User
Settings Mode, please refer to your
Owner's Manual.
www.youtube.com/KiaFeatureVideos
up increases intermittent wipe
A
C
25
Advertisement
Table of Contents
