Use - PACLITE Equipment Super Screed Operator's Manual

● When the machine is not being used for longer periods of time,then it must be stored in a dry and clean
area.
● Make sure that there is sufficient ventilation in spaces which are surrounded by walls.
● Never inhale exhaust gasses,they can damage your health and that of your colleagues.
● To avoid getting an electric shock,do not touch the high-tension cable or spark plug cap while the engine
is running.
● Check for fuel leaks before running the machine.
● Do wear working-gloves,safety glasses and protecting clothing during refilling of fuel.
● Make sure that there is sufficient ventilation during refilling fuel.
● Refilling fuel is only allowed after the engine has been cooled off sufficiently.
● Refilling fuel while the engine is hot might lead to a very dangerous situation
● Refiling fuel is prohibited in the direct vicinity of open fire,during cigarettes,a heat source and in
explosion dangerous areas.
● Do nou smoke during refilling fuel.

5. Use

READ THE MANUAL CAREFULLY BERFORE USE.IF ASPECTS ARE NOT CLEAR TO YOU ,CONTACT YOUR
DEALER OF THE SUPPLIER..
For the location and description of the SuperScreed's parts,which are mentioned in the text,we refer to the
illustration figure 2 is this manual.
5.1.Assembling the SuperScreed
a) First determine whether you want to use the SuperScreed as a form-to form screeder or as a weet screeder.
b) SuperScreed is supplied in 2 components:the power-unit and the blade profile.
c) The power-unit is equipped with a quick connection system,for easy mounting of the power-unit onto the
blade profile.
d) TO connect the power-unit to screed blade according to the figure 4,must be tight the lock nut.
e) Now unfold the twin control handle,adjust it to the proper height,and tighten the 2 clamps.
f) Make sure that the SuperScreed is properly assembled and that the ON-OFF switch is in the ON position.
Make sure that the fuel tank is filled(NO FUEL MIX).
g) In case the SuperScreed is used for form-to form screeding make sure that the rail supports are set to the
right level.
1. Screed blade
2.Plate
3. Locating sleeve
4. Big plain washer
5. Lock nut
2 3
Walk-behind Floor Saw Manual
4 5 1
7