Electrolux EUC05002W User Manual page 9

wall unit, the minimum distance between
the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however,
the appliance should not be positioned be-
low overhanging wall units. Accurate level-
ling is ensured by one or more adjustable
feet at the base of the cabinet.
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the dis-
tance between the wall and the cabinet
must be at least 10 mm to allow the door to
open enough so that the shelves can be re-
moved.
Warning! It must be possible to
disconnect the appliance from the
mains power supply; the plug must
therefore be easily accessible after
installation.
A
Door reversibility
Important! To carry out the following
operations, we suggest that this be made
with another person that will keep a firm
hold on the doors of the appliance during
the operations.
To change the opening direction of the
door, do these steps:
1. Remove the plug from the power socket.
2. Remove the top hinge cover.
3. Unscrew the 2 retaining screws, and re-
move the hinge from the appliance.
B
4. Take the door off.
5. Remove the screw fixing the lower door
hinge and the other screw fixing the low-
er door hinge and the foot. Then re-
move the door hinge and the foot as
shown in the Figure.
6. Loosen the screw fixing the foot oppo-
site the lower door hinge in order to re-
move the foot.
7. Fix the door hinge and the correspond-
ing foot on the opposite side and then
the other loosened foot at the former
place of the door hinge as shown in the
Figure.
8. Please make sure to place the low-
er foot below the door hinge. The
lower foot is recognizable by its 4
ribs on the outer surface.
9. Fix the door onto the lower hinge pin.
10. To fit top door hinge, remove the plas-
tic blanking plugs carefully, and refit
electrolux 9
2
1