Panel Facilities And Specifications - Pioneer PRO-700HD Service Manual

Projection monitor receiver
Table of Contents

Advertisement

PRO-700HD
8. PANEL FACILITIES AND SPECIFICAITONS
8.1 PANEL FAICLITIES
A flip-down door conceals the control panel. Push gently and
release, to open the door. To close the door, lift it back up into
place.
NOTE:
If you accidentally pull the door, it may not shut properly. Push
the door back in to shut it.
P U S
H
1
STANDBY/ON
272
In some cases, the door may only open slightly when pushed.
In such cases, open the door with your finger as shown in the
figure at left.
2
3
DTV
DPO
1 POWER STANDBY/ON indicator
2 DTV indicator
Lights when receiving a digital television broadcast.
If a digital tuner has been connected, the DTV indicator may
still blink even when the power has been turned off. (This is
not a defect.)
3 DPO sensor
Sensor to detect the room brightness.
4 MAIN POWER switch
Press once to turn on the main power (STANDBY mode). Press
again to turn off the main power.
5 POWER button (STANDBY/ON)
Press once to turn on the Monitor. Press again to turn off the
Monitor.
6 INPUT SELECTOR button
Press to select your program source. Each press of the INPUT
SELECTOR changes the selection to the next source.
TV
(DTV)
INPUT 4
INPUT 3
7 CHANNEL buttons
Press plus (+) or minus (–) to tune to a higher or lower channel.
Only the preset channels can be tuned in using these buttons.
4
5
STANDBY/ON
MAIN
POWER
POWER
SELECTOR
INPUT 1
INPUT 2
6
7
8
INPUT
CHANNEL
RETURN

Advertisement

Table of Contents
loading

Table of Contents