Stab Positioner Using Usals - Dreambox Two UltraHD User Manual

Follow these steps:
1. Press the Menu-Button to open the main OSD menu.
2. With the Navigation-Buttons ( ▲▼) choose the option "Setup" and press the OK-Butto.
3. With the Navigation-Buttons ( ▲▼) choose the option "Services and Recordings" and press the
OK-Button.
4. With the Navigation-Buttons ( ▲▼) choose the option "Service Searching" and press the OK-
Button.
5. With the Navigation-Buttons ( ▲▼) choose the option "Tuner configuration" and press the OK-
Button.
6. With the Navigation-Buttons ( ▲▼) choose the option "DVB-S2 Tuner" and press the OK-Button.
7. With the Navigation-Buttons ( ▲▼) choose the option "Mode".
8. With the Navigation-Buttons (◄►) choose the option "DiSEqC A/B/C/D".
9. With the Navigation-Buttons ( ▲▼) choose the option "Port A".
10. With the Navigation-Buttons (◄►) choose the desired Satellite.
11. With the Navigation-Buttons ( ▲▼) choose the option "Port B".
12. With the Navigation-Buttons (◄►) choose the desired Satellite.
13. With the Navigation-Buttons ( ▲▼) choose the option "Port C".
14. With the Navigation-Buttons (◄►) choose the desired Satellite.
15. With the Navigation-Buttons ( ▲▼) choose the option "Port D".
16. With the Navigation-Buttons (◄►) choose the desired Satellite.
17. Press the OK-Button to save this settings.
Make sure you know which satellite is connected to which input on the Toneburst switch. If you do not find
any services in the transponder scan later, exchange the mentioned satellites in this list and try again.

6.1.5 Stab Positioner using USALS

Use this type of configuration if you want to receive many satellites with a Stab positioner from a Single
Universal LNB. The coax cable is directly connected from your Dreambox to the LNB.
4 1