Connection Via Network Cable - Dreambox Two UltraHD User Manual

Manually setting an IP adress
These settings are only needed if you want to configure your Network manually.
1. With the Navigation-Buttons ( ▲▼) choose the cable based network "Wired" and press the OK-
Button.
2. Press the yellow Options-Button.
3. With the Navigation-Buttons ( ▲▼) choose the option "'Method (IPv4)"' and press the OK-
Button.
4. With the Navigation-Buttons (◄►) choose the option "'manual"' and press the OK-Button.
Address (IPv4) Enter the IP address here.
Free IP-Addresses: 192.168.0.2 - 192.168.0.254
Mask (IPv4) Enter the subnet mask (Usually 255.255.255.0).
Gateway (IPv4) Enter the router's IP address here, if the Dreambox is connected to the Internet by a
router.
Usually this is: 192.168.0.1
To save the settings and activate the network connection press the OK-Button.
DNS-Settings
1. With the Navigation-Buttons ( ▲▼) choose the cable based network "Wired" and press the OK-
Button.
2. Press the blue Options-Button to open the DNS-Settings dialog.
The colored buttons in this menu are mapped to the following functions:
red Options-Button Delete selected nameserver.
green Options-Button Add IPv4-nameserver.
yellow Options-Button Add IPv6-nameserver.
blue Options-Button Skip changes.
Note: If you have set the "Method (IPv4)" option to "dhcp" you won't have to enter anything here
since this will be done automatically.
Nameserver
Enter the DNS-Server's IP address here. DNS is used to translate a Domain name to an IP
address. Normally, if the Type is set to LAN, there is no need for a DNS entry. If the Dreambox is
connected to the Internet over a router, enter the router's IP address here.
3 4