Advertisement
DOCKING AND UNDOCKING THE COMPUTER
1. Turn the computer off.
2. With the slide plate in the open
position, insert the bottom of the
computer into the docking station. Make
sure the guide tabs are lined up with the
pockets on the back side of the
computer.
Rotate the top of the comptuter under the
top hooks until the computer is resting on
the two vertical walls sticking out from the
slide plate.
(see Figues 1, 2 & 3)
(Note: If your computer has an
extended battery or card slot
attachment on the back side, you will
need to remove the guide block from
the face of the dock before inserting
the computer.)
3. Push downward on the slide plate to
latch the dock. (See Figure 4)
4. (Optional) The key lock can now be
used for security purposes.
TO UNDOCK THE COMPUTER
1. Turn the computer off.
2. Unlock if locked.
3. Press the Latch Button. The slide plate
is spring loaded and should raise with your
hand when you release the button.
4. Rotate the top of the computer out of
the dock to remove.
Figure 1
Vertical Walls
Guide Block
Guide tabs
Figure 2
Figure 3
Figure 4
4/5
Advertisement
