Table of Contents
Advertisement
SETUP (continued)
UNPACKING AND INSTALLATION
14. Install the Binocular Assembly & Eyepieces to the Magni-
changer using knob 'X'.
15. Unscrew the Knob A Shown in Figure-5 to allow slit lamp to
travel on Metal Plate form.
16. Remove the accessories and store them in an Appropriate
place so that when they are needed they will be available.
Refer to figure-2 & 10.
17. Microscope is ready to use now.
APPLICATION OF INPUT POWER
WARNING: CARE MUST BE TAKEN TO ARRANGE THE CABLES
THRU CABLE COVER REFER FIGURE-9 FOR THE ACCESSORIES
SUCH THAT THEY DO NOT PRESENT A TRIPPING HAZARD TO
THE EXAMINER OR A DANGER TO THE PATIENT.
WARNING: POSITION THIS INSTRUMENT SO THAT IT IS NOT
DIFFICULT TO OPERATE THE DISCONNECTION DEVICE (PLUG).
1. After the unit is in its secure location, apply the correct
input voltage to the instrument using the Power Cord from
the Box.
NOTE: The power inlet is located on the backside of the Power
Supply Assembly.
2. Press down on the "I" located on the ON/OFF Switch. Refer
to figure-11.
NOTE: The Indicator just above ON/OFF Switch will illuminate
green when there is power to the unit. When the ON/OFF Switch
is set to off, the green light will turn off.
DISCONNECTION OF INPUT POWER
1. At any time, the power switch can be set to OFF. The unit
does not have a power down sequence. To terminate
operation of this instrument, press the ON/OFF switch to
the OFF position (O).
2. If this instrument is intended to be OFF for an extended
period of time, it can be disconnected from power by
detaching the power cord from the receptacle.
8126700-795
Microscope
Assembly
Cable Cover
Figure -9 Install Microscope
Figure-11 Power Supply Assembly
SL 20i
X
Figure -10 Accessories
Issue 1.0
Printed on June,2019
SL 20i
11
Advertisement
Table of Contents
