Troubleshooting - JVC KD-X172 Instruction Manual

Troubleshooting

Symptom
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
Source cannot be selected.
The unit does not work at all.
Correct characters are not • This unit can only display uppercase letters, numbers,
displayed.
• Depending on the display language you have selected
• Radio reception is poor.
• Static noise while listening
to the radio.
Playback order is not as
intended.
Elapsed playing time is not
correct.
"NOT SUPPORT" appears and
track skips.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reattach the device (USB).
Remedy
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. (Page 5)
Reset the unit. (Page 4)
and a limited number of symbols.
(page 6), some characters may not be displayed
correctly.
Connect the antenna firmly.
The playback order is determined by the file name (USB).
This depends on the recording process earlier (USB).
Check whether the track is a playable format.
(Page 14)
Symptom Remedy
"CANNOT PLAY" flashes and/ • Check whether the connected device is compatible with
or connected device cannot this unit and ensure the files are in supported formats.
be detected. (Page 14)
• Reattach the device (USB).
"NO DEVICE" Connect a device (USB), and change the source to USB
again.
If you still have troubles, reset the unit. (Page 4)
15
ENGLISH