Riverside Furniture 28032 Assembly Instructions

Riverside
email: info@riverside-furniture.com
Components and Hardware List
Desk Top
A
1 pc.
5 5
-18 x 35mm
16 16
Allen Head Bolt Allen Head Bolt
E F
8 pcs.
Be sure to check all packing material carefully for small parts, which may have come loose inside the carton during
shipment.
Step 1: Remove the drawers from the Desk Top (A) and lay them aside. Place the Desk Top on its back edge on a
clean, soft surface.
Step 2: Attach the Stretcher (D) to the Legs (B,C) by using 44mm long Allen Head Bolt (F), Spring Washer (G), Flat
washer (H) and Half Moon Washer (I), tighten with the 5mm Allen Key (J) as shown.
Step 3: Attach the Legs at the two sides of the Desk Top (A) using the 35mm long Allen Head Bolts (E), Spring
Washers (G) and Flat Washers (H). Tighten with the 4mm Allen Key (J).
Step 4: Carefully set the Desk upright and reinstall the drawers.
This is not A Stand-Alone Unit - Must Be Purchased With 2
Leaning Bookcases (One Bolted/Attached On Each Side)
To remove the drawer if it ever becomes necessary:
A. Pull the drawer fully open so the black latch is visible in
the inside channel of the guides.
B. Release the latches by simultaneously pushing left side
lever up and the right side down.
C. At the same time, pulling the drawer forward until the
slides release.
To reinstall the drawers, carefully align the channels of the
guide and push drawer back into cabinet. Open and close
drawer fully a couple times to verify proper operation.
FURNITURE
Assembly Instructions
Left Leg Right Leg
B C
1 pc.
5
-18 x 44mm
" x 12 x 2mm
16
Spring Washer
G
10 pcs.
2 pcs.
A
Perspectives
Wall Desk
Stretcher
D
1 pc.
5
" x 19 x 2mm
16
Flat Washer
H
10 pcs.
B
Made in Viet Nam
1 pc.
28032 / 28132 / 28232
Half Moon Washer
5mm Allen Wrench
J
I
2 pcs.
J
E
G H
H I
J
F
G
Bottom view
Page 1 of 2
1 pc.
C