TM
AutoTest
Brake Fluid Moisture Testing
Brake fluid is designed to have a high boiling point to withstand the high temperatures generated by friction in the
vehicle brake system. Unfortunately brake fluid readily absorbs moisture from air that transfers through the flexible
rubber hoses. Moisture reduces its boiling point leading to possible brake failure.
Overseas studies have highlighted that over 50% of vehicles on the road today may have fluid that is too old to be
within safety standards. Just like oil, brake fluid wears out and then it is simply not as reliable as fresh new brake fluid.
In addition, moisture contaminated brake fluid can corrode internal engine parts.
The AutoTest™ Brake Fluid Tester measures the moisture content in vehicle brake fluid. It provides accurate results in
less than one minute that allows users to identify vehicles that require a brake fluid change. Consequently, it increases
sales of brake fluid and brake fluid flushes.
The Brake Fluid Tester also increases the value of quick lube inspections, seasonal brake checks and routine
servicing.
Enhance your reputation for customer care and protect your clients by providing a brake fluid safety check.
It's not age and mileage that determines brake fluid change intervals; it's moisture absorption. Brake fluid gradually
absorbs moisture from the air. Moisture enters through the flexible hoses and reservoir breather. Absorbed moisture
reduces the boiling point of brake fluid. Under
prolonged hard braking conditions, particularly in hot weather or when a vehicle is heavily loaded, heat from the
braking action can suddenly
vaporize the fluid. Vapor unlike liquid is compressible and the driver's foot suddenly goes straight to the floor resulting
in complete loss of
brakes, known as Vapor Lock.
The AutoTest™ Brake Fluid Tester is inserted into the master cylinder reservoir on the car and clipped onto the
battery. When the
button is pressed, a small sample of the fluid is heated up to boiling point where the temperature is recorded by an
accurate electronic
thermometer and displayed. This display alternates with the specified minimum boiling points so that it is instantly
clear if the fluid needs to be changed or is within specification. The meter can be withdrawn and the display will
continue so that it can be shown to the car owner.
Disconnecting the battery then resets the meter for use again. There is no additional cost of consumables, nothing to
order and stock and the
meter is practically maintenance free.
The test itself can be completed in less than one minute and it can then lead to a complete overhaul of the braking
system where appropriate. Customers appreciate work that may have a direct impact on their safety and that of their
family.
Unique Features
•
Ergonomic Design
•
User Friendly
•
Checks brake fluid condition in under 1 minute
•
Operates off 12 volt supply – vehicles own battery
•
LCD display screen instructions lead operator through the complete test sequence
•
Increase brake servicing revenue
•
Suitable for use on new brake fluid and racing fluids
Product dimensions: 2250mm (h) x 1000mm (w) x 806mm (d)
Brake Fluid Tester
Need help?
Do you have a question about the Brake Fluid Tester and is the answer not in the manual?