Features - Urrea SOLT1025 User Manual And Warranty

12. Proper cylinder care. Secure cylinders to a
cart, wall, or post, to prevent them from fall-
ing. All cylinders should be used and stored
in an upright position. Never drop or strike a
cylinder. Do not use cylinders that have been
dented. Cylinder caps should be used when
moving or storing cylinders. Empty cylinders
should be kept in specified areas and clearly
marked "empty."
13. Never use oil or grease on any inlet connec-
tor, outlet connector, or cylinder valves.
14. Use only supplied Torch on this TIG welder.
Using components from other systems may
cause personal injury and damage components
within.
15. People with pacemakers should consult
their physician(s) before using this product.
Electromagnetic fields in close proximity to a
heart pacemaker could cause interference to,
or failure of the pacemaker.
16. USE PROPER EXTENSION CORD. Make
sure your extension cord is in good condition.
When using an extension cord, be sure to sue
one heavy enough to carry the current your
product will draw. An undersized cord will
cause a drop in line voltage resulting in loss of
power and overheating. A 50 foot extension
cord must be at least 12 gauges in diameter,
and a 100 foot extension cord must be at least
10 gauges in diameter. If in doubt, use the next
heavier gauge. The smaller the gauge number,
the heavier the cord.
DUTY CYCLE
Duty Cycle is the equipment specifications
which defines the number of minutes within
a 10 minute period that a piece of equipment
can safely operate.
This TIG welder has a 40% duty cycle, which
means that it may be used only 4 minutes at
250 Amps out of any 10 minute period, and
must be rested the remaining 6 minutes.
CAUTION: Failure to observe the duty cycle
limitations of this Plasma Cutter can easily
damage this equipment, and will void war-
ranty.
E N G L I S H •

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1
2
7
1. Power Switch. Up is ON, down is OFF.
2. Digital Amps Meter. Shows actual welding
current, which will vary during operation.
3. Thermal Overload Indicator Lamp. This light
will come on, and the device will shut down
if the tool becomes overheated. Stop trying to
use the cutter while leaving the power switch
onto allow the cooling fan to operate, and the
lamp will turn off automatically when the ma-
chine cools down. Please pay attention to the
Rated Duty Cycle.
4. Power supply Indicator Light. It will be on
when the machine is power supplied.
5. Power Supply Controller: It can adjust weld-
ing current.
6. Mode selector: Select MMA welding or TIG
welding:
" " Means MMA welding, when you chose
this welding mode, please plug the welding
plug with cable to the TIG control socket.
" " Means TIG welding, when this TIG
welding mode is selected, please plug the TIG
torch control cable in to TIG control socket.
7. Ground connector.
U se r's m a n ua l
4
3
5
6
10
8
9
15