Before The First Use - Professional Series PS77199 User Manual

BEFORE THE FIRST USE

— To ensure the first cup of coffee tastes excellent, you should rinse the coffee
maker with warm water as follows:
— Pour water into water tank, the water level should not exceed the "MAX" mark in
the tank. Then replace the water tank cover.
— Note: the appliance is supplied with a detachable tank for easy cleaning, you
can fill the tank with water first, and then put the tank into the appliance.
— Set steel mesh into metal funnel (no coffee in steel mesh).
— Place an espresso cup (your own cup) on removable shelf. Make sure the steam
control knob is on the OFF position.
— Note: the appliance is not equipped with jug, please use your jug or coffee cup.
— Connect to power source, press down the ON/OFF button to the lower position
which is the "1" position. The red lamp will be illuminated.
— Press down the pump control button to the lower position which is the "P"
position, the pump will pump water, when there is water flowing out and close
the pump by pressing and release the pump control button, make sure the
coffee/steam button is on the higher position which is the
waiting for a moment, the appliance begins to be pre-heated until the green
lamp is illuminated, it shows the pre-heating is finish. Pressing the pump to the
lower position which is the "P" position again, and water will flow out.
— Once water is no longer dripping, you can pour the water in each container out
then clean them thoroughly, now you can start brewing.
— Note: There may be noise when pumping water for the first time, it is normal,
the appliance is releasing the air in the appliance. After about 20s, the noise will
disappear.
PRE-HEATING
— To make a cup of good hot Espresso coffee, we recommend you preheating the
appliance before making coffee, including the funnel, filter and cup, so that the
coffee flavour can not be influenced by the cold parts.
— Remove the detachable tank and open the tank cover to fill it with desired water,
the water level should not exceed the "MAX" mark in the tank. Then place the
tank into the appliance properly.
— Select the one-cup or the two –cup mesh. Set steel mesh into metal funnel,
make sure the tube on the funnel aligns with groove in the appliance, then insert
the funnel into the appliance from the "Insert" position and release the press
bar, and you can fix them into coffee maker firmly through turn it anticlockwise
until it is at the lock position.(See fig. 1).
— Place an espresso cup (your own cup) on the removable shelf.
— Then connecting the appliance to power supply source. Make sure the steam
control knob is on the OFF position.
— Press the ON/OFF button to the lower position which is the "1" position, the red
lamp will be illuminated, make sure the coffee/steam button is on the higher
position which is the position. Press down the pump control button to the
lower position which is the "P" position, when there is water flowing out, close
the pump immediately. The purpose of this step is to pump the water of the tank
into the housing.
— When the green lamp is illuminated, you should press down the pump control
position and