Changing Between Fahrenheit And Celsius; Adjusting The Temperature Setting; Adjusting The Timer Setting; Locking/Unlocking The Settings - Hatco FWM Series Installation And Operating Manual

English
Standby Shutdown
Use standby shutdown to put the waffle maker in standby mode
during extended periods of non-use.
1. Press the button to shut down operation and put the
unit into standby mode. The light will be red.
• The heating elements and LED display will shut down.
Daily Shutdown
Use the following procedure to shutdown the waffle maker at
the end of each day.
1. Press the button to shut down operation and put the
unit into standby mode.
2. Move the Power I/O switch located on the back of the unit
to the O (off) position to turn off power to the unit.
3. Perform the "Daily Cleaning" procedure in the Maintenance
section of this manual.

Changing Between Fahrenheit and Celsius

1. Make sure the unit is in standby mode. Refer to the
"Standby Shutdown" procedure in this section.
2. Press and hold the
• The LED display will show either "F" or "C" to indicate the
active unit of measure.

Adjusting the Temperature Setting

NOTE: If the buttons are not pressed within seven
seconds during programming, the unit will revert to
showing the current timer setting without making any
changes.
1. With the unit in operating mode, press the
• The LED display will show the current setpoint
temperature.
2. Press the or button to increase or decrease the
setting to the desired setpoint temperature.
3. Press the button three times to lock in the new setpoint
temperature and return the display to operating mode.
NOTE: The unit will operate normally during the temperature
adjustment period after a setpoint temperature change.
Form No. FWMM-1021
button for three seconds.
button.

Adjusting the Timer Setting

NOTE: If the buttons are not pressed within seven
seconds during programming, the unit will revert to
showing the current timer setting without making any
changes.
1. With the unit in operating mode, press the
times.
• The two characters that represent "minutes" will flash on
the LED display.
2. Press the or
setting to the desired number of minutes.
3. Press the button.
• The two characters that represent "seconds" will flash on
the LED display.
4. Press the or
setting to the desired number of seconds.
5. Press the button to lock in the new timer setting and
return the display to operating mode.

Locking/Unlocking the Settings

Use the following procedure to prevent unauthorized changes
to the temperature and time settings. The
will continue to function normally when the settings are locked.
1. Press and hold the
appears on the LED display, then press the
• A beep will sound, and the LED display will show "Lc".
The settings are now locked.
NOTE: If the settings are locked when the unit is turned off, they
will be locked when the unit is turned on again.
To unlock the settings:
1. Press and hold the
appears on the LED display, then press the
• A beep will sound, and the LED display will show "Unlc".
The settings are now unlocked.
9
OPERATION
button to increase or decrease the
button to increase or decrease the
and
button for five seconds until "- - - -",
button for five seconds until "- - - -",
button two
buttons
button.
button.