Bullet tools Vinyl Glider Operation

The
1. Retract blade by turning depth knob
Continue to rotate knob if you would like to remove it completely.
2. Unlock guide fence
➋ B
3. Slide guide fence
4. Place the Bullet Vinyl Glider over an LVP plank.
a. Set the LVP plank onto the handle side runner.
➋
B
5. Slide guide fence
a. Set the LVP plank onto the fence side runner.
b. Vinyl plank should be captured on both sides.
➋
B
6. Lock guide fence
7. Unlock blade receiver
8. Slide blade receiver
9. Lock blade receiver
10. Extend blade by turning knob
11. Press firmly down on knob
a. If needed, extend blade further and slide the glider back along the vinyl plank.
PATENT PENDING
PATENT PENDING
➊
A
counterclockwise. You can stop when blade is fully retracted into the receiver.
➋ ➌
B
by lifting latch lever
to the widest position.
up to the plank
by pressing down on latch lever
➍
D
by lifting latch lever
➍
D
to the desired position (the right side is calibrated to the scale).
➍
D
by pressing down the receiver latch lever
➊
A
clockwise. Blade should cut into LVT by about 1/16" (1.5mm).
➊
A
and slide glider along the full length of your vinyl plank.
12. Slide the glider off the end of the plank.
13. Flex the vinyl plank up, then down - to snap it along the line.
E
TM
Operation
C
.
➌
C
.
➎
E
.
➎
E
.
A
D
C
ALWAYS OPERATE OVER A
SOLID AND SECURE SURFACE
(such as a concrete or wood floor)
B
#BT92-2095