Select Your Kind Of Display; How To Set The Kind Of Display; How To Set The Resolution Of A Crt Display - HP 81200 Installation Manual

Start the System

Select your kind of Display

Select your kind of Display
NOTE: This step is required only for proprietary systems based on the HP E4840A or E4849A/B. For others
your Windows NT Display properties are taken.
At power on the display driver is set to a mode that supports both CRT and the flat panel option 001
(Display and Entry Panel). Therefore the resolution is set to 640 x 480 pixels.
Once the Windows desktop is displayed, you need to inform the operating system about your display:
• if you are using the Display and Entry Panel, the display properties should remain unchanged
• if you are using an external monitor define the appropriate settings

How to Set the Kind of Display

1. Double-click the WinNT Control icon on the Windows desktop or in the "Start" −> "Settings"−>
"Control Panel"
2. Activate your display from the window
Figure 5 WinNT Display Control Panel
• Select CRT if you have connected a monitor to the controller
• Select Panel if you are using the Display and Entry Panel option
• Select CRT/Panel if you are using both, CRT and Display and Entry Panel. The display resolution
is determined by the Display and Entry Panel.
3. Click OK.

How to Set the Resolution of a CRT Display

The standard screen controller supports resolutions up to 1024 x 768 pixels. The default setting after
activating CRT is 800 x 600 pixels.
To set or reset the screen to 1024 x 768 pixels:
1. Press Ctrl+Esc.
This opens the Windows START menu. The Windows task bar may not be accessible.
2. Click Control Panel (alternatively, press the Cursor down key and then Enter).
This opens the system control menu.
46