Table of Contents
Advertisement
Getting Started
Steps to Get Started
Steps to Get Started
Initial Inspection
When you receive your HP 81200 system inspect the container and its contents.
NOTE:
If the contents are incomplete, if there is mechanical damage or if the instrument does not pass the
selftest, notify your nearest Hewlett-Packard office. Keep the shipping materials for inspection by
the carrier. The HP office will arrange for repair or replacement without awaiting settlement.
1 Inspect the shipping container and its contents for damage.
If the container or cushioning material is damaged, keep it until the contents of shipment have
been checked for completeness and the instrument has been verified both mechanically and
electrically.
WA RN IN G
To avoid the hazard of electric shock, do not perform electrical tests when there are signs of
shipping damage to any of the instrument's outer covers or panels.
2 Check the contents of shipment.
NOTE:
See the packing list which accompanied your system for exact details.
Determine Your System
Please use the box content list to determine your system configuration, than follow the setting up
instructions provided for that system type.
Factory pre-installed as a proprietary system, the HP 81200 System has the following major
configurations
• Based on the 3-slot small mainframe HP E4840A, see setup instructions
System based on HP E4840A Small Mainframe" on page 18
• Based on the 10-slot mainframe HP E4849A/B, see setup instructions
System based on HP E4849A/B Mainframe" on page 22
• Based on the mainframe HP E4849A/B and extender frame HP E4848A/B, see setup instructions
"Setting up an Extended HP 81200 System based on HP E4849A/B and HP E4848A/B
Mainframes" on page 26
An extended HP 81200 system includes up to two HP E4848A/B Expander Frames, each equipped
with an MXI/VXI Interface Card HP E1482B. Each Expander Frame has 12 free slots.
The HP E4849A/B mainframe includes also an HP E1482A MXI/VXI Interface card, so there are
9 free slots.
If the HP 81200 System components are ordered to be used in an open VXI system your shipment may
contain:
• at least on clock module, either an HP E4805A Central Clock Module or the HP E4831A Clock &
Data Module.
• a number of HP E4841A Data Generator & Analyzer Modules equipped with the ordered front-
ends.
12
"Setting up an HP 81200
"Setting up an HP 81200
Advertisement
Table of Contents
