First Steps To Use The Touchpad Of The Option 001 Display And Entry Panel - HP 81200 Installation Manual

First steps to use the Touchpad of the Option 001 Display and Entry Panel

When Option 001, Display and Entry Panel is connected to the HP 81200 System, then a Touchpad
(Glide Point) unit, which is part of the panel, is simulating a conventional mouse.
When the system has booted then there is a Touchpad icon in the right corner of the status bar, at the
lower right-hand side corner of the display.
Figure 25 Touchpad Icon in the Status Bar
1 Put your finger tip onto the Touchpad. Keep your finger on the Touchpad and glide your finger
across the pad and watch the movement of the cursor.
2 Now move the cursor to the Touchpad Icon.
3 Now tap on the surface of the Touchpad, this is the same as clicking the left mouse button. You
will see the following touchpad enhancements menu.
Figure 26 Touchpad Enhancements Menu
4 When you click on Tutorial, you get additional information on how to get familiar with the
touchpad
First steps to use the Touchpad of the Option 001 Display and Entry Panel
Setting up a proprietary System
Touchpad Icon
35