Coltri Sub POLARIS Use And Maintenance Manual page 31

ENGLISH
COLTRI SUB technicians are at your disposal for all routine/unscheduled
maintenance work.
Please forward your request for assistance to COLTRI SUB by sending a
fax or e-mail to:
The regulator can mounted on a diving cylinder in either of two
configurations:
- "INT connector" 230 bar: ISO/DIS 12209-1:1998
- "DIN connector" 230-300 bar: ISO/DIS 12209-2 & 3:1998
WARNING: This regulator, complying with EN 250, is not intended
for more than one diver to breathe from at the same time.
If this regulator is configured and used by more than one diver at
the same time, then cold water and breathing performance may
not fulfill the requirements of EN 250.
Recommendations:
A regulator will offer optimum performance in the following situations:
Water temperature between 50 F to 95 F.
Air supply must be conform to the breathing air standard.
The regulators are equipped with low pressure (LP) ports of 3/8" and high
pressure (HP) ports of 7/16".
Buoyancy compensators LP hose and drysuit hose can be installed on
available LP ports. The pressure gauge needs to be installed on the HP
port. For added security, the use of a cylinder with dual outlet valve
(Y-valve) will allow for a secondary back-up regulator.
WARNING: The air contained in the tanks must conform to the
requirements for breathable air set out in EN12021:1999.
POLARIS
SINTHESIS
CRUISER OCTOPUS
ASSISTANCE
Fax. +39 030 9910283
coltrisub@coltrisub.it
USE
31 - 48