Bosch PAS0720 Instructions For Use Manual page 45

• Remove the basic filter from the appliance,
Fig. 28.
• Insert the double active filter + positioner in
the basic filter as shown on Fig. 30,
remembering that it must be housed on the
lower studs first.
clack!
2
• Install the assembly onto the appliance by
lining the lower studs up with the slots on
the front casing of the appliance and
pressing the top clip in until it clicks into
position. The assembly is fitted properly
when it clicks into position.
• Close the front flap.
Important!
Fit only one set of filters onto the support
in order to ensure correct appliance
operation.
Notes:
The front flap can also be removed in order
to clean the appliance or change the filters
more easily. To do this, open the flap up to
the safety stop (the flap opens to a slight
angle, Fig. 30) and pull outwards firmly. In
order to refit it, line the lower studs on the
flap up with the holes on the casing until
the studs meet the tabs on the casing.
Cleaning and Maintenance
Fig. 29
Fig. 30
clack!
1
Storage requirements
When the appliance is out of use for a long
period, fit the outdoor unit onto the indoor
unit so that the appliance takes up as little
space as possible. See "Transportation
requirements".
Wind the hose up and secure it with clamp B,
Fig. 1. Fig. 31.
Fig. 31
Prior to use at change of season
Clean the basic filter and, if necessary,
change the purifying filter.
Then clean the upper and side air directors
to eliminate dust and dirt.
Remember to unwind the hose carefully
when preparing the appliance for use (see
Important Information).
45