Table of Contents
Advertisement
Document PTS-RR-PSC-5-2019-3-5
User Educational Requirements
Prior to use of the PSDS, the user should have completed the Raytheon Operators
Course. The user should have a thorough understanding of Raytheon operations and a
basic understanding of the PSC-5 set-up and configurations.
Operation of PSDS with Raytheon Radios
SAFETY NOTICE: Power down the radios and ensure the PSDS power switch is in the
off position prior to installing or connecting radios. Failure to do so may result in
electrical shock.
Basic PSDS Set-Up
Radio Installation
Facing the PSDS slide and fully connect the rear of the PSC-5 onto the J1 connector
utilizing the two guide pins to ensure alignment. Lock the PSC-5 onto the PSDS by
securing the pre-positioned locking tabs.
Antenna & Handset Installation, Radio Configuration
To ensure proper operation an OE-254/GRC antenna (not the manpack antenna) must
be connected to the amp or you will experience excessive noise. Connect the antenna
connector to the installed amplifier. The user needs to place the antenna 100 feet away
from the PSDS using LMR-400 antenna cable. Attach the appropriate handset. Inspect
the AC power cable for cuts, frays or other damage. If damaged, replace the power
cable. Plug the appropriate power cable into the back of the PSDS and into the AC
power source (grid or generator power, worldwide). You are now ready to perform radio
operations.
Note: The PSDS provides worldwide auto switching power adjustment. As long as the
proper power cable is used for the AC power source, the PSDS will automatically adjust
to the provided input. If the power is "dirty" and experiencing fluctuations, the PSDS will
continually adjust for these changes.
PTS, Inc.
6
Advertisement
Table of Contents
