Maintenance - babymoov 232386 Instruction Manual

Points to respect for trouble-free use:
- always check that the bottle is slightly open (not screwed down too tightly).
- always remove the lid from the jar.
- optimum heating will be guaranteed provided operation is not interrupted.
- use tap water only, with no added product.
NB: always use the large basket to heat bottles and jars.
1. Fill the bottle warmer measure (a) with water up to the mark indicated.
2. Put the big basket (b) in the bottle warmer and pour the water into the bottle warmer tank (c).
3. Put the bottle in the bottle warmer tank (c).
4. If the bottle is too large, remove the adaptor ring (d).
5.Put the jar in its basket (e) then put the basket in the bottle warmer tank (c). Don't forget to remove the
adaptor ring before installing the basket.
6. Plug the appliance into the mains: 200V/230V. Check that the indicator lamp (f) is green.
7. Press the "On" button (g) to start the appliance.
8. The lamp (f) will turn red to show that the appliance is working. Remark: the appliance can't be stopped using
the "On" button. It will go out automatically and an audible alarm will tell you that the bottle or jar is ready.
9. Remove the bottle or jar immediately using tongs or a cloth because they will be hot. Shake the bottle to mix
the milk. Pour a drop of milk on the back of your hand to check its temperature. For a jar, mix the contents
and check it is not too hot.
Cleaning:
- Wait until the bottle warmer is cold before cleaning it.
- Always unplug the appliance before cleaning it.
- Never submerge the appliance in water, and don't fill it right up with water.
- Do not use any kind of detergent to clean the inside and outside.
- Adaptor ring, measure and baskets can be washed in the dishwasher.
De-scaling:
Do not use any de-scaling products. Depending on the quantity of water used is and after a certain period of
time, a layer of scale may build up in the tank (f). In order for the sterilizer to work properly, the tank needs to
be de-scaled regularly.
Proceed as follows: Mix 100 ml hot water with 100 ml white vinegar and pour it all into the tank (c). Leave to
act for 30 minutes then empty the appliance.
Then use a damp cloth to clean it.
• The bottle warmer doesn't heat up:
- check that the appliance is plugged in.
- check the "On" button to make sure it is properly switched on.
• The warming cycles are too short or too long:
- there is not enough or too much water; be sure to use only the amount indicated.
8
STEAM BABY BOTTLE WARMER WITH DOUBLE ALARM• Instruction Manual

MAINTENANCE

IN CASE OF ANY LITTLE PROBLEMS