¹ Communication between ODU to DOAS to be 18AWG, 4 conductor ² LG requires that LATS software be used on all projects to ensure correct line sizing. Designer must verify the shop drawing design against the as built design Using LATS. Contractor must also use LG manufactured Y-Branch and Header Kits only.
DOAS Unit Address Setting LG DOAS can be connected maximum 4 Unit in on ODU system. If more than two DOAS units are installed, DOAS and HR Unit (Assembled inside of DOAS) addresses must be matched. Factory set value is 0 Figure38: Address Setting in Multiple DOAS Application Due to our policy of continuous product innovation, some specifications may change without notification.
Page 51
CAUTION The Limited Warranty is void and of no effect, and LG will have no liability hereunder to any Customer or third party, to the extent any of the following occur: acts, omissions, and conduct of any and all third parties including, but not limited to, the installing contractor and any repairs, service or maintenance by unauthorized or unqualified persons.
Need help?
Do you have a question about the ARND30UDBE4 and is the answer not in the manual?
Questions and answers