Advertisement
Changing the Frame
tm
MemoryVue
supports changeable frames so you can change the look of the frame as the décor changes. Use
the following instructions to change the frame:
Lay the digital frame on a flat surface with the scrfeen facing down. Make sure the surface is flat and protected
to avoid scratches.
Using a #6 Philips head screwdriver and the illustration below, remove the 4 screws that fasten the frame to the
unit. Lift the digital frame unit up, turn it over, and lay it down in another area. The frame should be left on the
protected surface. Note the location hole in the matte
Lift the removed frame from the surface. Replace this frame with the new frame, making sure the orientation of
the remote sensor hole in the new frame is the same as the other.
Lift the digital frame unit up, turn it back over, and place it over the frame, aligning the mounting holes, and
making sure the remote sensor hole on the unit and the hole on the matte are aligned.
Use the four screws that were removed to fasten the new frame. The unit is now ready for display.
Frame Mounting Screw
Frame Mounting Screw
Rear Case of MemoryVue
Frame Mounting Screw
Frame Mounting Screw
1767-M0-Po-5
Advertisement
Table of Contents
Need help?
Do you have a question about the MemoryVue MV-1040 and is the answer not in the manual?
Questions and answers
How can I retrieve the photo content from a Memory Vue 1040 where the screen is failing.
To retrieve photo content from a Digital Spectrum MemoryVue MV-1040 with a failing screen, access the internal storage by connecting the device to a computer using a USB cable or by removing the memory card (if used) and inserting it into a compatible card reader. This allows you to copy the photo files directly from the device or card to your computer.
This answer is automatically generated