Earthing Instructions; Water Supply Requirements; Floor Requirements - Whirlpool LSA1300 User Manual

Whirlpool | User Manual
• To minimize possible shock hazard, the
cord must be plugged into a mating outlet.
If a mating outlet is not available, it is the
personal responsibility and obligation of
the customer to have the properly earthed
outlet installed by a qualified electrician.
• Earthing should be done in accordance
with local codes and ordinances. It is
recommended that a qualified electrician
determine that the earth path is adequate.
• Do not earth to a gas pipe.
• Do not have a fuse in the neutral or earth
circuit.
• When in the installed position the mains
plug must be accessible for disconnection.
• Do not use manual stabilizer
Electric Shock Hazard
Electrically earth this appliance.
Do not use an extension cord or an electrical
portable outlet device.
Failure to follow these instructions can result in
death, fire or electric shock.

EARtHING INStRuCtIoNS

This washer must be earthed. In the event
of a malfunction or breakdown, earthing will
reduce the risk of electric shock by providing
a path of least resistance for electric current.
This washer is equipped with a separate earth
wire. The earth wire must be connected into
an appropriate outlet that is properly installed
and earthed in accordance with all local codes
and ordinances.
IMPORTANT : Improper connection of the
equipment-earthing conductor can result in a
risk of electric shock.
Whirlpool corporation
responsibility for damage caused by failure to
observe this rule.
Check with a qualified electrician or serviceman
if you are in doubt as to whether the appliance
is properly earthed.
Do not modify the plug provided with the
appliance – if it does not fit the outlet, have
a proper outlet installed by a qualified
electrician.
6

WAtER SuppLy REquIREMENtS

• Cold water tap with 3/4" BSP threads not
more than 1m from the rear side of the
Washer and at a height of at least 1.3m from
the foot level.
• If connected to hot water supply, ensure
that the temperature should not exceed
70
machine.
• The water
storage
tank should
correspond to
a level of 2 to
80 m above the
level of tap and
water pressure
from 0.2 to 8
kgf/cm
• In case of inadequate water pressure,
customer has to correct the water supply to
improve flow rate or pour water manually.
• Suggestion to improve water flow Rate:
• Tank height from water inlet tap should be
greater than 10 ft (Refer Picture)
• Ensure no blockage in water line.

FLooR REquIREMENtS

• Installing on a carpet is not recommended.
• Floor must support the washer's total weight
(with water and cloth load) of 143 kg.
• The floor should have a floor drain or a hole
(according to plumbing laws), where the
washer is installed. This will ensure draining
away any water which may overflow from
the washer due to malfunction or hose
leak.
• Do not place the machine on a slanting,
uneven or unstable surface.
• Place the machine on a solid leveled surface
to avoid excessive vibration and noise
during operation.
declines any
o
C. It may cause a fault or damage to the
2