Sony MAV-2000 Operation Manual page 20

1 POWER indicators A, B, C
Light in green when the respective power switches are
set to ON.
If they flash in red with the power switches ON, there
is a problem. In such a case, contact authorized Sony
service personnel.
2 BUSY indicator
Flashes in amber when a port(s) is(are) open.
The flashing cycle depends on the number of open
ports.
When turning off the power to this unit, check that the
BUSY indicator is off.
3 SYSTEM (system status) indicator
Lights in green when the server is operating normally.
If any error occurs, it flashes in red.
If it flashes in amber, the server may operate but have
some problems.
In a case that this indicator flashes in red or amber,
contact authorized Sony service personnel.
4 REF VIDEO (reference video input) connectors
(BNC type) and 75-ohm termination switch
Connect an analog composite video signal, such as
black burst.
The two connectors are in a loop-through state. When
the loop-through output is not used, set the 75-ohm
termination switch to ON.
5 TC-IN (time code input) connector (BNC type)
To accept a time code signal.
6 VS-BUS connector (BNC type)
Connect it to a device equipped with a VS-BUS
connector to control this server.
7 SBX-IN (serial bus extension input) connectors
(BNC type)
Connect them to the SBX OUT connectors OUT1 or
OUT2 of the MAV-S2000.
8 SBX-OUT (serial bus extension output)
connectors (BNC type)
Connect them to the SBX IN connectors IN1 or IN2 of
the MAV-S2000.
9 STATUS OUT connector (D-sub 9-pin)
Outputs various status data on the server, including
operating modes and errors.
q; ETHER (Ethernet) connectors (10BASE-T,
RJ-45 modular jack, conforming to Ethernet
IEEE802.3)
Connect the ETHER-2 connector with the Ethernet
connector of the host computer.
This connector can be used to transmit the AV data
recorded on the server system to external systems.
The ETHER-1 connector is for spare.
qa POWER A/B/C switches
Press the side of the switches to turn the respective
power blocks ON. To turn OFF, press the
Be sure to set all three switches to ON.
qs POWER A/B/C connectors
Connect the optional power cords, respectively.
qdU (signal ground) terminal
For signal ground. Connect when required.
BKMA-2010 I/O Processor Board (Option)
1 REMOTE connectors (D-sub 9-pin, conforming
to RS-422A standards)
For control of the input/output signals of the respective
ports. Connect them to the RS-422A connectors of
editing units.
2 SDI IN (serial digital video/audio input)
connectors (BNC type)
Digital video/audio inputs. Depending on the system
settings, the connectors accept either 525/59.94- or
625/50-component serial digital signals.
For the system settings, refer to the Installation Manual.
3 SDI OUT (serial digital video/audio output)
connectors (BNC type)
Output the serial digital video/audio signals.
4 AUDIO IN AES/EBU (digital audio input)
connectors (BNC type)
These connectors accept up to four pairs (8 channels:
CH1/2, CH3/4, CH 5/6, CH7/8) of digital audio signals
of the AES/EBU format.
5 AUDIO OUT AES/EBU (digital audio output)
connectors (BNC type)
These connectors output up to four pairs (8 channels:
CH1/2, CH3/4, CH 5/6, CH7/8) of digital audio signals
of the AES/EBU format.
side.
7 (E)