worldpay P400 Integration Manual

WorldPay P400 Integration Guide

Note: Before the integration can begin, you will need to obtain your E mboss MID (5 digits) and

TID (8 digits) from W orldPay Total . WorldPay will typically email this information across to you,

however if you have not yet received this you can contact them on 0845 366 6015 .

Currently this WorldPay card reader is o nly compatible with Windows till systems.

Installing the

p p

The steps below will need to be completed via G oogle Chrome u sing a Windows till system or

laptop/PC/smartphone.

1. Log into your

2. Select A PPS (left hand side)

3. Click onto a ny app (the URL bar will look something like this -

https://www.eposnowhq.com/Apps/App/111 ) ; remove the numbers from the end of

the URL bar and replace them with 5 54 a nd select enter on your keyboard

4. On the next page, select G ET FREE APP

5. Select INSTALL FREE APP

The WorldPay app will now be installed on your Back Office.

Physical card reader setup

Connecting to Epos Now

You will receive a

a rd

Note:

D o n ot connect the USB to the

the

a rd

e ader section of this guide.

1. Plug one end of the U SB cable into the card reader

E pos Now Back Office

e ader and a USB

t ill system

v ia Google Chrome ( e posnowhq.com )

a ble.

u ntil you reach step 8 in the C onfiguring

Table of Contents

Need help?

Do you have a question about the P400 and is the answer not in the manual?

Page 1 Note: Before the integration can begin, you will need to obtain your E mboss MID (5 digits) and TID (8 digits) from W orldPay Total . WorldPay will typically email this information across to you, however if you have not yet received this you can contact them on 0845 366 6015 . ...
Page 2 Note: The other end of the USB cable will plug into one of the USB ports on the underside of the till system. Do not do this until you reach step 9 of the configuring the card reader section of this guide. ...
Page 3 18. Go back to the Y ESEFT folder and double click on Y ESEFTConfig.bat 19. Under the G eneral Tab , tick A lways send Transaction Results 20. Then select V erifone P400 as the P in Pad 21. Then tick A utoSensing COM Port ...
Page 4 You will then see a pop up on the screen confirming that Epos Now software is connecting to the WorldPay card reader, be sure to check the card reader screen to see if it’s showing the amount. If the transaction amount is showing on the card reader, you can now take payment. The till ...
Page 5 I’m getting an error on my card reader when I try to process a transaction, how can I fix it? I f you are seeing an error on the card reader screen, you will need to contact WorldPay directly. Any errors that appear on the card reader screen indicate an issue with the card reader rather ...