Shop-Vac QPL Series User Manual page 7

5. With tank drain facing you, take caster foot marked with the letter A and place
in slot on left side of tank also marked with the letter A and secure with screw
provided.
6. Take caster foot marked with the letter B and place in slot on right side of
tank also marked with the letter B and secure with screw provided.
7. Insert casters into feet by placing stem of caster into holes provided. Apply pressure
and twisting motion until casters snap into place.
8. Return tank to upright position.
9. If an accessory basket came with your unit, place basket with curved surface against
tank on rear caster dolly assembly. Push downward until basket snaps onto dolly. The
basket is not included with all models.
plaStIC taNk wItH rear wHeel baSket
You will find two casters, two caster feet, two rear wheels, one axle, one basket and four screws
with your vacuum.
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so
that bottom is facing up.
2. Stand axle upright on hard surface and hammer on one cap nut.
3. Place one wheel on axle and slide down to cap nut. Be sure flat side of wheel hub is
facing outward.
4. Slide axle through holes provided in basket.
ASSEMBLY (CONT'D.)
Screw
Caster
Foot
Screw
Caster
Foot
PAGE 7