Table of Contents
Advertisement
This introduction has touched on some of the more important points
of the console to give gene:cal information Vii thout excessive de-.
tails.
Those concerned with the daily operati.on should study I;he
section labeled OP...otul:J'ION.
The insta.Llation cre"l should study
their section before actually starting the Vlork.
Bach section is
broken down to cover different phases so that unnecessary confusion
may be eliminated and the answer to any particular question may be
easily found.
'1'he engineering staff is urged to become acquainted
with all sections so that they can advise other groups in the best
performance, as \vell as being able to keep the console in top
operating condi.tion.
INSTALLATION
All the packing material, including any shipping frames and plat-
forms, should be carefully removed prior to the installation of
the J:16158 ..
l
Stereo Control Console.
The removable items include:
6
994 6034 OOl
Transistor Preamp1ifi.ers.
2
994- 6034 001
Transistor Booster Ampl i f i.ers
(same as the Pream,;lif iers).
2
994- 5700 001
'I'rans istor Program Amplifiers.
1
994- 6035 OOl
Transistor Cue··· Intercom
Amp Ufier.
1
992 1335 001
Phone Jack Plate.
1
472 0429 000
Power Transformer
1
646 0379 000
Group of Knob Decals.
1
888 0939 001
Insi.;luccj,Oll
i'lanualo
If any of the i'ems listed above are missing, search all of the
packing materi.al again to determine if they have been overloolwd.
If still missing, contact the Gates Hadio Company for instructions.
SIZE:
deep.
The I16158A Console is 53-1/2" long, 11,·3/8" high and 17.-3/8
11
The net weight is 107 pound.s.
With the plug-in amplifiers removed, place the console on the con-
trol desk in the final operating positi.on.
Determine the routing
of the interconnecting cables into the cabinet and the method of
co=ecting the cables to the control desk.
The conduit and/or
duct layout should also be considered in the pla=ing of the
interconnecting cable runs.
If the cables are to come up through
the surface of the desk, mark the cable access holes (in the con-
sole base) on the desk top so they may be accurately drilled after
removal of the cabinet.
In some cases,it is preferred to elevate the console cabinet
sufficiently to permit the cables to lay between the desk top
and the console base, making a right angle turn '-lith the cables
to enter the cabinet.
The cables are then dressed off the rear
of the desk and generally a protective cover is installed down
the rear of tho desk.
6/26/62
-2·-
The Executive
Advertisement
Table of Contents
