Gates Radio Company 994-6158-02 Instruction Book page 58

Stereo transistor console
Table of Contents

Advertisement

TECHNICAL DATA
Gain:
53 db (matching 600 ohm).
39 db min. (bridging 6,000 ohm)
Frequency Response:
~
1.0 db from 20 to 20,000 cps
@ normal output level.
Harmonic Distortion:
Under 1.0% from 30 to 15,000 cps
@
+
39 dbm output
(8
watts).
Intermodulation Distortion:
Under 1.0% at +
38
dbm
e~uivalent
sine wave power output, using
40
and 7000 cps mixed 4:
1.
Noise Level:
- 85 db below rated outpuLle-rel
(+
39 dbm).
Source Impedan0€s:
600 ohms for 600 ohms matching input.
150/600 for 6000 to 10,000 ohm
bridging input.
Input Impedances:
600
ohms
matching input,
balan~ed
(transformer input).
6,000 ohms, bridging input, balanced
(bridging pad and transformer input)"
Load Impedances:
4
to
16
ohms
(r"ted
at
8
ohms),
lill-'
balanced (transformerless output,
isolated from AC ground by power
transformer)
g
Output Impedance:
1.2 ohms, approximately.
Maximum Input Level:
o
dbm.
Maximum Output Level:
+
40
into
8
ohms (10 uatts).
Maximum Operating Ambient TemperatUIe:
55° C.
(131° F.)
Maximum star'age Ambient Temperatur'e:
85°
c.
(185°
F.)
Power Requirements:
117 Volts at 50/60 cps", 18 watts.
Transistors:
2
1
2
2N1414
2N2J.4
2N1l83
Rectifiers:
1
2
2Ni)087
2N3614
4
X5A2
(silicon)
Finish:
Light grey
cover,
fla~
black heat
sink chassis.
M.ounting:
Two keyhole slots, rubber bumpers on
bottom, permanent or movable mounting
in any position.
Size:
3-1/4'1 high, 4-3/8
11
deep, 8-1/2
11
long.
Weight:
4 lts", net.
7 lbs., packed.
Cubage:
0.9 cu.
ft.
~m;;stic
pack.
DESCRIPTION
cthe 116108A Monito", Amplifier is a trans-
istorized, self-contained amplifier de-
signed for use in broadcasting, record-
ing, and general sound reinforcement
applications"
Spe?ial techniques have
been employed to obtain reliability,
-1-
low di3tortion,
a.~ld
good temperature sta-
bili ty"
The amplifier can be mounted in
any position and does not requiTe ventil-
ation when handling 8 watts of program
material"
The input, power, output con"'::"
nections, fuse and input level control
are mounted. on end panels of the chassis.

Advertisement

Table of Contents
loading

Table of Contents