Setup - TRNDlabs SPECTRE User Manual

Charging SPECTRE
Connect the USB Charging Cable to an USB port and battery. The LED on
the USB Charging Cable lights red indicating that the battery of the drone is
charging. When the battery is fully charged, the LED on the USB Charging
Cable turns off. It takes about 30 minutes to recharge a discharged battery.
Make sure you only charge the rechargeable battery with the supplied
USB Charging Cable. Trying to charge the rechargeable battery with a
different battery charger might cause serious damage.
WARNING
8

Setup

Controller Battery Installation
Open the Controller battery cover.
1
2
Install 4x 1.5V AA batteries.
3
Slide the Controller battery cover back.
2
1
3
Mobile Phone Installation
Place your mobile phone in the holder
by opening the clip and placing the
phone in the holder. Now gently close
the clip. The mobile phone is protected
by two foam cushions inside the clip.
Rotor Protector Installation
Gently slide the Rotor Protectors onto the
landing feet of the drone (4x).
9