Logitech RALLY Setup Manual page 9

PAIRING THE REMOTE
Your camera and remote control are paired at the factory However, if you need to pair
a remote to the camera (such as when replacing a lost remote) do the following:
1. Press and hold button on the back of the camera until LED flashes blue
2. Press and hold the Video Mute button on the remote for 10 seconds to place it
in pairing mode
3. Once the remote and camera are paired the LED will stop flashing
4. If the pairing fails, the LED will keep flashing Start from step 2 and repeat
FOR MORE INFORMATION
You can find additional information on Rally including:
– FAQs
– Firmware Upgrades
– Software Downloads
– Support Community
– Warranty Information
– Replacement Parts
– And more at
www.logitech.com/support/rallycamera
English 9