Sony DVP-NS500V Operating Instructions Manual page 24

Connecting to a stereo amplifier (receiver) and 2 speakers/Connecting to an
C
MD deck or DAT deck
This connection will use your 2 front speakers connected to your stereo amplifier (receiver) for
sound. If the stereo amplifier (receiver) has audio input jacks L and R only, use
amplifier (receiver) has a digital input jack, use
deck, use
C-2
deck without using your stereo amplifier (receiver).
xRecommended surround sound effects for the
TVS STANDARD (page 55)
z
In connection
z
To realize better surround sound effects, make sure that your listening position is in between your speakers.
Note
SACD audio signals are not output from the digital jack.
SACD/DVD player
COAXIAL OPTICAL
PCM/DTS/
DOLBY DIGITAL
DIGITAL OUT
C-2
COAXIAL OPTICAL
PCM/DTS/
DOLBY DIGITAL
DIGITAL OUT
to coaxial or optical digital input
[Speakers]
Front
(L)
Front
(R)
l: Signal flow
24
. In this case, you can also connect the player directly to the MD deck or DAT
C-1
, you can use the supplied audio/video cord instead of using a separate audio cord.
L
C E N T E R R – AUDIO 1 – L VIDEO 1
R – AUDIO 2 – L VIDEO 2
R
FRONT REAR W O O F E R
5.1CH OUTPUT
LINE OUT
Coaxial digital cord
(not supplied)
Optical digital cord
(not supplied)
Remove jack cap
before connecting
Stereo amplifier (receiver)
. When connecting to an MD deck or a DAT
C-2
Y
1
P
2
B
P
R
S VIDEO
COMPONENT
OUT
VIDEO OUT
Stereo audio cord
(not supplied)
or or
(white)
connection only
C-1
(red)
R – AUDIO 1 – L VIDEO 1
(white)
R – AUDIO 2 – L VIDEO 2
LINE OUT
(red)
to audio input
MD deck/DAT deck
. If the
C-1
C-1