Disassembly Procedure For Main Board - TC Electronic G-Force Service Manual

Disassembly Procedure for Main Board

1. Turn Off Power and Disconnect Power Cord.
2. Loosen 5 screws, see fig. 1, and remove the top cover.
3. Disconnect front connector, J1, see fig. 2.
4. Remove screws at MT7, MT8, MT2 on the main board, see fig. 2.
5. Remove 5 nuts at the Jack connectors on the back panel, see fig. 3.
6. Remove screw at SPDIF in/out connector, see fig. 3.
7. Push the main board into the front profile a little to free the connectors from
the back panel, then lift out the board.
8. Desolder the seven wires from power supply.
Fig. 3: Screws at back panel.
PROFESSIONAL
AUDIO EQUIPMENT
LISTED
5D83
______________________________________________________________________________________________________________________________________________________________________________
_________________
TC Electronic A/S
2 nuts 2 nuts
Fig. 2: Screws and front connector at main board
G-Force Service manual
Fig. 1: Screws at top lid
5 screws
Top view
main board
J1
MT7 MT8 MT2
Top view
MIDI / RS485
1 screw
Power
Supply
Jack nut
page 7