Ryobi GD200A Operator's Manual page 46

USING THE INDOOR KEYPAD
See Figure 80.
WARNING:
Keep moving door in sight when using indoor keypad.
Contact with moving door can cause DEATH or serious
injury.
The indoor keypad has backlights that turn on when garage
door opener is connected to a power supply. When the
keypad is locked, the backlights will blink.
 Install and wire the indoor keypad as described earlier in
the Installation section.
 To raise or lower the garage door, press and release the
UP/DOWN button.
 To enter and exit vacation mode, press and release the
LOCK ( ) button. When the unit is in vacation mode, it
Up/Down
Button
Light
Button
Lock
Button
OPERATION
 To turn the LED lights on and off, press and release the
Activating and Deactivating Accessory Ports:
 To activate a accessory port, press the number on the
 To deactivate a accessory port, press the number on the
Accessory
Port #7
Accessory
Port #3
Accessory
Port #4
46 - English
can only be controlled using the indoor keypad and smart
phone. The unit will not respond to car remotes or the
outdoor keypad.
NOTE: The LEDs in the indoor keypad will blink when the
unit is in vacation mode.
LIGHT ( ) button.
NOTE: When the LIGHT (
light will illuminate for three minutes.
indoor keypad corresponding with the desired port. For
example, to activate accessory port #2 press NUMBER 2
on your keypad.
NOTE: An active accessory port can be used to power
DC accessories. Multiple ports can be activated at once.
indoor keypad corresponding with the port.
Accessory
Receptacle
Port #1
AC
Accessory
Receptacle
Port #5
) button is pressed, the LED
Accessory
AC
Port #2
Accessory
Port #6
Fig. 80