Ryobi GD200A Operator's Manual page 17

 Repeat this process to attach a support rail, second
sleeve, second support rail, third sleeve, and then the
the third support rail. When assembled correctly, the rails
should not separate easily when pulled.
 Pull the front pulley and belt through top of the rail
assembly.
 Turn the tension nut on the pulley rod counterclockwise
to loosen. Remove the tension nut and spring from the
pulley rod.
Support
Sleeve
Rail
Support
Rail
Pulley
Rod
Spring
Tension
Nut
Front
Brace
ASSEMBLY
Sleeve
Fig. 13
Sleeve
Fig. 14
Front
Pulley
Fig. 15
Support
Front
Rail
Pulley
Fig. 16
 Insert the pulley rod into the front pulley.
NOTE: Ensure the head of the rod is fully seated in the
pulley.
 Move the front pulley back into the rail assembly.
 Insert the edge of the front brace into the rail assembly.
Slide together until brace clicks in place. If you cannot
get the brace to fit by hand, try gently tapping it with a
rubber mallet until it is snug.
 Pull the front pulley forward and slide the rod through the
hole in the brace.
 Install spring and tension nut onto pulley rod.
 Move the inner and outer trolley to the middle of the rail
assembly.
Pulley
Rod
Spring
Tension
Nut
Tension
Nut
Front
Brace
17 - English
Front
Brace
Spring
Support
Rail
Fig. 17
Fig. 18