Installing And Removing The Battery Pack; Operation - DeWalt DCH263 Instruction Manual

English
Fig. E
13
Bit and Bit Holder

WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage bare hands.
The rotary hammer can be fitted with various chisel bits
depending on the desired application. Use sharp drill
bits only.
SDS Chuck (Fig. F)

WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage bare hands.
To insert bit, insert shank of bit about 3/4" (19 mm) into
chuck 15 . Push and rotate bit until it locks in place. The bit
will be securely held.
To release bit, pull the sleeve
Fig F
15
16

OPERATION


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
10
14
back and remove the bit.
16

Installing and Removing the Battery Pack

(Fig. G)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
8
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 9 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. G
9
8
Proper Hand Position (Fig. H)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the mounted
side handle 1 , with the other hand on the main handle
Fig. H
1
Operation Modes (Fig. I)

WARNING: Do not select the operating mode when
the tool is running.

CAUTION: Never use in Drilling or Hammerdrilling
mode with a chisel bit in the bit holder. Personal injury
and damage to the the tool may result.
Your tool is equipped with a mode selector dial
select the mode appropriate to desired operation.
into the tool handle, align the
6
to
4
.
6