Oil Burner Technology - Econo Heat OMNI EH-350 Installation, Operation And Service Instructions

This pressure system is 150-200 psi and has the ability to control lame even when various
viscosities are used- furnace or stove oil to 90 weight straight- lame remains stable
Transformer
Oil Primary
Photo Eye/Flame Sensor
(CAD Cell)
Flame Cone
Solenoid Valve
Electrodes
Nozzle
Flange
Figure 5 – Oil Pump Assembly

Oil Burner Technology

Atomization Through Low Pressure
Oil Preheater
Suction Line
Preheat & Air Induction At Nozzle
Inside Burner
Oil Tank
Filter
Internal Pump Filter
EconoHeat's patented burner technology improves the eficiency of the oil burn process by
continuous stabilization of the oil viscosity. Optimum atomization (spray) is accomplished by
precisely pre-heating the oil prior to introduction to the combustion chamber. The waste oil
enters into the Oil Pre-Heater Block and is pre-heated to operating thermo set-point, and this
along with high pressure (100 psi to 500 psi depending on model) break up the oil droplets
into a iner mist or spray (atomization). Electrodes mounted just above the nozzle provides
continuous electrical arc across electrode to electrode igniting the ine oil mist as it sprays out
of the nozzle. Once ignited the lame is forced into a swirl caused by the burners blower and
specially designed lame cone providing a very eficient and thorough burn of the waste oil.
EconoHeater by EconoHeat Page 10