Siemens HB676G0.6M User Manual And Installation Instructions page 20

Table of Contents

Advertisement

en Self-cleaning
If smoke is emitted, the appliance must be switched
off or the plug must be pulled out and the door
must be held closed in order to stifle any flames.
Loose food remnants, fat and meat juices may catch
fire when the cleaning function is in progress.
Before starting the cleaning function, always remove
the worst of the food residues and remnants from
the cooking compartment and accessories.
The outside of the appliance gets very hot when the
cleaning function is in progress.
Never hang combustible objects, e.g. tea towels, on
the door handle.
Leave the front of the appliance clear.
Keep children at a safe distance.
If the door seal is damaged, a large amount of heat is
generated around the door.
Do not scrub or remove the seal.
Never operate the appliance if the seal is damaged
or missing.
Remove coarse dirt from the cooking compartment
1.
and from the accessories.
Use a detergent solution and a soft cloth to clean
2.
the surfaces at the edges of the cooking compart-
ment around the door seal.
Do not remove or scrub the door seal.
Use oven cleaner to remove stubborn dirt from the
inner door pane.
To clean an accessory as well, insert the accessory
3.
at level 2.
Note: Only clean accessories that were included
with the appliance and that are enamelled, e.g. the
universal pan or the baking tray. Wire racks are not
suitable for the cleaning function and will become
discoloured.
Remove any objects from the cooking compartment.
4.
The cooking compartment must be empty except for
the accessory that is also being cleaned.
17.2 Setting the self-cleaning function
Ventilate the kitchen while the cleaning function is run-
ning.
WARNING ‒ Risk of harm to health!
The cleaning function heats up the cooking compart-
ment to a very high temperature so that food left over
from roasting, grilling and baking will burn off. This pro-
cess releases vapours, which can irritate mucous mem-
branes.
Keep the kitchen well ventilated while the cleaning
function is running.
Do not remain in the room for long periods.
Keep children and pets away.
WARNING ‒ Risk of burns!
The cooking compartment gets very hot when the
cleaning function is in progress.
Never open the appliance door.
20
Allow the appliance to cool down.
Keep children at a safe distance.
The outside of the appliance gets very hot when the
cleaning function is in progress.
Never touch the appliance door.
Allow the appliance to cool down.
Keep children at a safe distance.
Requirement: → "Preparing the appliance for the
cleaning function", Page 19.
Press
⁠ .
1.
Select "Self-cleaning" in the operating mode menu.
2.
Use the rotary selector to set the cleaning setting.
3.
Cleaning set-
Cleaning
ting
level
1
Light
2
Medium
3
High
Select a higher cleaning setting for heavier or older
soiling.
The duration cannot be changed.
Press
⁠ .
4.
a A notification stating that you should carry out the
necessary preparatory work for the cleaning func-
tion appears in the display.
Press
to start.
5.
a The cleaning function starts and the duration counts
down. The heating line does not appear.
a For your safety, the appliance door locks once a
certain temperature is reached in the cooking com-
partment.
a When the cleaning function ends, a signal sounds
and the duration is at zero in the display.
Press
to switch the appliance off.
6.
When the appliance has cooled down sufficiently,
the appliance door is unlocked and  goes out.
7.
→ "Preparing the appliance for use following the
cleaning function", Page 20.
17.3 Preparing the appliance for use
following the cleaning function
Allow the appliance to cool down.
1.
Wipe off any ash that has been left behind in the
2.
cooking compartment, on the rails and around the
appliance door with a damp cloth.
Slide the pull-out rails in and out several times.
3.
While the cleaning function is running, the rails may
become discoloured. This discolouration does not
compromise the functionality of the appliance.
Remove white residues with lemon juice.
4.
Note: White residues on the enamel surfaces may
be caused by heavy soiling. These food residues
are harmless. The deposits do not compromise the
functionality of the appliance.
Duration in hours
Approx. 1:15
Approx. 1:30
Approx. 2:00

Advertisement

Table of Contents
loading

Table of Contents