Operating Instructions - Wap Alto SQ 450-11 Operating Instructions Manual

PLEASE READ THE
OPERATING
INSTRUCTIONS AND
OBSERVE THE SAFETY
PRECAUTIONS!
INTENDED USE
When employed in
accordance with their
intended use, the
industrial vacuum cleaners
described in these
operating instructions are
suitable for picking up
non-flammable, dry dusts
and liquids. They
correspond to dust class
'L'.
BESCHREIBUNG (Fig. 1)
1 Handle
2 Appliance switch
3
Suction force regulator
4
Retaining clamp
5 Dirt tank
6 Inlet fitting
7 Compressed air
connection
8
Appliance plug socket
9
Accessory drawer
ASSEMBLING THE
CLEANER
CAUTION!
On delivery, the
accessories - except the
telescopic tubes
packing of the cleaner) -
are lying in the tank and
must be removed before
the cleaner is used for the
first time.
Option/model variant
1)
6
Bedienungsanleitungen auf www.gluesing.net
Remove the cleaner top
section:
The mains plug must not
yet be inserted into a plug
socket.
• Open the retaining
clamps and lift off the
cleaner top section
(Fig. 2).
• Place a bag-type filter
into the tank as
described in the
instructions (printed
on the filter).
• Fit the cleaner top
section and close the
retaining clamps.
• Connect the suction
hose. The 'Wap
MultiFit' enables any
Wap suction hose
systems (27, 32, 36,
50 mm diameter) to
be connected to the
cleaner.
1)
(Fig. 3).
ELECTRICAL/
1)
COMPRESSED AIR
CONNECTION
The operating voltage
shown on the rating plate
must correspond to the
voltage of the mains
power supply.
•
Ensure that the
cleaner is switched
1) (in the
off and insert the plug
of the mains lead into
a properly installed
and fused plug socket
with earthing contact.
CONNECTING ELECTRIC
TOOLS
• Connect the electric
tool to the appliance
plug socket on the
control panel (Fig.4).
Before connecting a
tool, ensure that
both the cleaner and
the tool are
switched off.
Maximum power
consumption of the
electric tool to be
connected, see table
'Technical Data'.
CONNECTING
PNEUMATIC TOOLS
• Connect the
pneumatic tool to the
quick coupler
control panel.
• Connect the
compressed air supply
to the nipple (Fig.4).
1)
Before connecting a
tool, ensure that
both the cleaner and
the tool are
switched off.
Working pressure of
the pneumatic tool to
be connected, see
table 'Technical Data'.
on the
1)