Installing The Handlebars; Installing The Pedals - Juiced Bikes SCORPION 2021 Owner's Manual

OPERATION
Fig. 13 - Inserting Front Wheel
3. Align the disk between the brake caliper as shown.
4. Insert the skewer into the wheel axle as shown. Keep the
spring, cam follower, and lever on the LEFT side, nearest
the disk brake. Keep the adjustment nut and spring on the
right side.
14
Fig. 14 - Inserting Skewer
5. Screw the skewer into the end nut until almost tight.
6. Lift the lever up and lock into place by closing it behind or
to the front of the fork. The lever must not be parallel to
the fork. You should feel the axle tighten into the front
forks. Your front wheel is now installed.
7. Be sure to inspect that your front wheel is secured properly
before every ride and adjust if necessary.
JBP-SCRP-MANUAL | © 2021 JUICED BIKES

INSTALLING THE HANDLEBARS

1. Point the headset towards the front of the bike.
2. Center the handlebar in the headset, taking care not to
damage any wires.
3. Install the clamp and screws. Alternately tighten the screw
side-to-side until secure.
4. Verify that the front tire lines up with the headset.
5. Verify that all headset items are tight.
Fig. 15 - Installing the Handlebars
JBP-SCRP-MANUAL | © 2021 JUICED BIKES
OPERATION

INSTALLING THE PEDALS

NOTICE
It's critical that the pedals are tightened firmly in the crank arm to prevent the pedals
from loosening while riding, which will result in significant damage to the bike.
1. Identify the left and right markings on the pedals. Be sure
to install the pedals on their respective side.
"L" is for the left pedal and is installed on the left crank
•
arm.
"R" is for the right pedal and is installed on the right crank
•
arm (chain side).
Fig. 16 - Left and Right Identification Marks
NOTE: Both pedals tighten toward the front of the e-bike.
2. While keeping the pedal horizontal, carefully hand-start
15