Assembly; Installing The Front Wheel (Mag Wheel); Installing The Front Wheel (Spoke Wheel) - Juiced Bikes SCORPION 2021 Owner's Manual

3

ASSEMBLY

Visually inspect your shipping box and the e-bike to see that
everything arrived without shipping issues. Take pictures if you
suspect excessive rough handling and contact
support@juicedbikes.com.
Watch our assembly videos and feel free to invite a handy
friend. Call us with any assembly questions. Also, you can e-mail
support@juicedbikes.com and we can send you more specific
information. We often generate new user guides based on the
feedback we receive from our customers.
Charge the battery pack. See "Charging the Battery Pack" on
page 31.
NOTICE
The kickstand is designed to support the e-bike only. Do not sit on the e-bike with
the kickstand engaged. Sitting on the e-bike with the kickstand engaged could result
in damaged to the kickstand.
NOTICE
The front wheel must be inspected before every ride to ensure it is securely attached
to the bike. Failure to test that the front wheel is properly secured could result in
significant injury or even death.
12
INSTALLING THE FRONT WHEEL
(MAG WHEEL BIKES)
Remove the shipping spacer, bolt and nut from the front wheel
fork.
1. Remove the spacer between the front disc brake caliper.
Do not squeeze the front brake handle. Squeezing the front
brake handle will cause the pads to move and it may be
difficult to position the front brake disc within the pads.
Fig. 10 - Removing Shipping Spacer
JBP-SCRP-MANUAL | © 2021 JUICED BIKES
2. Insert the axle into the front wheel hub. Position the wide
spacer (chain drive side) and slim spacer (disc brake side)
on the axle. Insert the front wheel in between the forks
while positioning the front brake disc in the brake caliper.
Spacers must be in between the forks.
3. Place a washer onto the axle on the outside of the forks.
Fig. 11 - Installing the Front Wheel
4. Install and hand-tighten the two adjustment nuts equally.
Use the supplied 15 mm socket and 15 mm wrench to
finish tightening the adjustment nuts, being sure each nut
is tightened equally on both sides.
5. The adjustment nuts must be very tight; be sure to
retighten them after your first two rides.
JBP-SCRP-MANUAL | © 2021 JUICED BIKES
ASSEMBLY
INSTALLING THE FRONT WHEEL
(SPOKE WHEEL BIKES)
Remove the shipping spacer, bolt and nut from the front wheel
fork.
1. Remove the spacer between the front disc brake caliper.
Do not squeeze the front brake handle. Squeezing the front
brake handle will cause the pads to move and it may be
difficult to position the front brake disc within the pads.
Fig. 12 - Removing Shipping Spacer
2. Insert the front wheel in between the fornt fork on the
bike. Be sure the fork is resting on the outside of the axle.
13