Lotus cooker PC1T-64G Instructions For Installation And Use Manual page 36

left until the thermal power reaches 1,15 kW: this procedure is possible only after having let the oven burner
work at maximum output for about 20 minutes.
Then turn the thermostat round to the minimum position and adjust.
After regulating, check lighting at both maximum and minimum output. Make sure that, when changing
rapidly from minimum to maximum output, the flame does not present any problems and does not go out when
closing or opening the oven door quickly.
Warning: When working with liquid gas the regulating screw must be screwed right down.
• The appliance contains the instructions necessary for use.
• Check the appliances for gas leaks.
• Check the lighting and flame of the main burner.
• We urge the user to follow the instructions when using the appliance.
With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must be done only by specialised personnel, observing the norms in force and our indications.
Open rings:
The cocks can be changed by removing the front panel; to change the thermocouples and burners you have to remove
Gas oven
the gas-cock, timer, thermocouples, burners and ignition plugs can be changed by accessing them inside the oven and/or
by removing the bottom oven panel or control panel..
Attention! The appliance must only be used under surveillance.
LIGHTING AND REGULATING THE GAS OVEN BURNER
GB
CHECKING FUNCTIONING
MAINTENANCE
SPARE PARTS
the rungs and trays.
INSTRUCTIONS FOR USE
LIGHTING AND ADJUSTING THE OPEN RINGS
On the front panel, above each knob, the burner it corresponds to is indicated by the index
Use a lighter to light the gas: turn the knob to the left, from the "0" position to the
(see figure), hold it down and light the gas.
Keep the knob pressed a few second and then let it go, this lights the pilot.
If the flame goes out you have to repeat the procedure.
By turning the knob round to the
By turning the knob round to the
To switch off, move the knob back into position " 0".
To light, turn the knob to the left from the "0" position to any one of the positions between
and 250 (see figure); keep the knob pressed until the gas lights.
You can check the flame through the inspection hole on the bottom of the oven; after a few
seconds let got of the knob. If the flame goes out repeat the procedure. Turn the knob round
to the temperature position wanted.
To turn the oven off, turn the knob to the right until it reaches position 0.
Attention: - When the oven is working, the door must not be left open because it can heat
and probably damage the knobs.
IE
IT CH
position the burner is at maximum
position the burner is at minimum.
36
sign