Table of Contents
Advertisement
LOADING AND UNLOADING THE VIDEO CASSETTE TAPE
Use only video cassette tapes marked
Preparation: Press TV/VCR to select TV/VCR mode.
LOADING
Push the centre of the tape until it is automatically inserted.
AUTOMATIC POWER ON AND PLAY (Make sure that the MAIN POWER switch is pushed in.)
When loading a cassette tape without the erase prevention tab intact, the unit will turn on and playback will
start immediately.
Insert the cassette with its labelled side facing you.
An inverted cassette cannot be inserted.
UNLOADING
1
To unload a video cassette, press
EJECT) on the unit twice. The first
press will stop the tape in any mode. The second
press will eject the tape.
AUTOMATIC EJECT
When the unit is automatically rewinding the tape and
reaches its end (AUTO REWIND), the tape will be ejected
automatically (See NOTE on page 18).
•
NOTES:
Always eject the tape when not in use.
•
The cassette can be ejected even if the Sub Power (
TO PREVENT ACCIDENTAL ERASURE
After recording, break off the erase prevention tab if
you do not wish to record over the tape.
Erase prevention tab
TAPE SPEED AND MAXIMUM RECORDING/PLAYBACK TIME
TAPE SPEED
SP (Standard Play )
LP (Long Play)
5N40301A [E] P14-23
.
PAL
(STOP/
Screwdriver
E-300
E-240
5 hours
4 hours
10 hours
8 hours
17
2
Pull the cassette out.
) button is OFF.
TO RECORD AGAIN
Cover the hole with adhesive tape.
Be careful the tape does not extend past the edges of
the cassette housing.
Adhesive tape
VIDEO CASSETTE TAPE
E-180
E-90
3 hours
1-1/2 hours
6 hours
3 hours
12/24/04, 4:47 PM
E-60
E-30
1 hour
30 minutes
2 hours
1 hour
17
Advertisement
Table of Contents
