U-Line 1 Class UHRF124 User Manual & Service Manual page 15

USER GUIDE
4. Remove door by tilting forward and lifting door off
bottom hinge. Retain shoulder washers; they will be
reused.
5. Insert arrow clips into holes
Remove bottom hinge:
1. Remove bottom hinge from cabinet using a 1/4"
socket.
2. Remove corresponding screws on opposite side of
cabinet. On some models there may be a nut behind
one or both screws on either side.
Install bottom hinge:
Install two or three screws, depending on model. Replace
nuts if used.
Prepare door for reinstallation:
1. Remove outside gasket.
Rotate gasket 180 º and press firmly into the gasket
2.
channel starting at the corners.
3. Reposition inside gasket.
a. Before rotating door,
measure distance from
top of outside gasket to
top of inside gasket.
b. Measure the same
distance up from the
outside edge of the
gasket and place a light
mark on each side of
door.
Door Adjustments
Top of Door
a
Place a mark
on each side
b
c. Using a flat tool, such as a putty knife, gently pry
off inside gasket.
º and
d. Rotate door 180
marks on door and firmly press gasket into place.
(If the original adhesive no longer holds the gasket
in place, it may be necessary to apply a strip of
two-sided tape.)
Install top hinge and door:
Top Hinge
Left Side
1. Remove pivot screw from hinge, flip hinge over, and
install the pivot screw in the same hole from the
opposite surface.
2. Lift the door onto the bottom hinge.
3. Align edge of the hinge with the outer edge of the unit.
4. Tighten three screws and replace hinge cover.
5. Replace hinge cover.
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT)
15
u-line.com
line up top edge of gasket to
Top Hinge
Right Side
Pivot
Screw