Ford EDGE 2021 Supplemental Owner's Manual page 94

Changing a Road Wheel
E178186
7. Remove plastic wing nut and jack and
lug wrench assembly.
8. Detach the lug wrench from the jack
by turning the jack hex nut drive screw
counterclockwise. This will lower the
jack and loosen the mechanical lock.
9. Unfold the wrench for use.
E181744
10. If your vehicle has wheel trim covering
the lug nuts, use the tool provided
with the jack assembly to remove the
wheel trim.
2021 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202011, First-Printing
11.
12.
E294117
E336095
13.
14.
15.
91
(If Equipped)
E294584
Loosen each wheel lug nut one-half
turn counterclockwise, but do not
remove them until the wheel is raised
off the ground.
If your vehicle has a warning triangle
and you are jacking the vehicle on the
roadside shoulder, set the warning
triangle upright on the shoulder of the
road facing the direction of oncoming
traffic.
Arrows depict vehicle jacking points
on the underside of the vehicle at the
locations shown above. The warning
label on the jack depicts the details.
Find the arrows embossed on the
vehicle downward flange next to the
tire you are changing.
Position the jack so that the vehicle
downward flange rests in the jack
saddle flange between the arrows,
as shown above. Raise the vehicle by
using the lug wrench to turn the jack
nut clockwise. Once the flat tire is off
the ground, remove the lug nuts with
the lug wrench.