Advertisement
Step 14
å
Carefully stand your unit upright.
å
Open the FURNITURE TIPPING RESTRAINT KIT (98) and fasten the SAFETY STRAP to the TOP/BOTTOM (E). Use
the provided short screw.
å
Place your unit in its final location against a wall. Locate the center of a stud in your wall near your unit and mark it
with a pencil. Next, drill a 1/8" hole on the mark and into the stud in your wall.
å
Fasten the unit to the wall. Use the long screw through the other end of the strap and into the 1/8" hole.
å
Peel APPLIQUES from the APPLIQUE CARD (7) and stick them onto each visible SCREW head.
å
Peel the BUMPERS from the BUMPER CARD (6) onto the TOP/BOTTOMS (E) shown where they come in contact with
the DOORS (C).
Drill 1/8" hole into
a stud in your wall.
98
Electric drill with 1/8" bit
(ONLY in indicated step)
Page 18
Use the short screw through the
hole in the strap and into the top
surface of the TOP/BOTTOM (E).
98
6
(16 used)
7
To cover SCREWS
www.sauder.com/service
E
C
C
426928
Advertisement
