Disposal - Siemens CM836GP.6 User Manual And Installation Instructions

en Disposal
Fault
Appliance does not heat up and
"Demo mode is switched on" ap-
pears in the display.
The appliance does not start and
"Cooking compartment too hot"
appears in the display.
The time is not displayed when
the appliance is switched off.
HomeConnect is not working cor-
rectly.
During simple microwave opera-
tion, the cooking compartment
becomes hot.
The interior lighting does not
work.
Maximum operating time
reached.
A message with "D" or "E" ap-
pears in the display, e.g. D0111
or E0111.
The cooking result is not satis-
factory.
24 Disposal
Find out here how to dispose of old appliances cor-
rectly.
24.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Unplug the appliance from the mains.
1.
Cut through the power cord.
2.
Dispose of the appliance in an environmentally
3.
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
32
Cause and troubleshooting
There has been a power cut.
Open and close the appliance door once after a power failure.
▶
a The appliance is checked and is ready to use.
The cooking compartment is too hot for the selected dish or type of heating.
Allow the cooking compartment to cool down and start again.
▶
Basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 24
Different causes are possible.
Go to www.home-connect.com.
▶
The drying function is switched on.
The LED light is defective.
Note: Do not remove the glass cover.
Call the after-sales service.
▶
→ "Customer Service", Page 33
To prevent an unwanted permanent operation, the appliance automatically stops
heating after several hours if the settings are unchanged. A message appears in
the display.
The point at which the maximum operating time is reached is determined by the
corresponding settings for an operating mode.
1. To continue operation, switch off the appliance with
Then use to switch on the appliance and set the required operation.
2.
Tip: To prevent the appliance from switching off when you do not want it to, set
a cooking time.
The electronics have detected a fault.
Switch the appliance off and on again.
1.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the
2.
exact error message when calling.
→ "Customer Service", Page 33
Settings were unsuitable.
Setting values, e.g. temperature or cooking time, depend on the recipe, quantity
and food.
Next time, set lower or higher values.
▶
Tip: A lot of information about the food preparation and corresponding set-
ting values can be found on our website www.siemens-home.bsh-group.com .
first.
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.