Wiring 8X Periphery Modules - YASKAWA VIPA FM 050-1BS00 Manual

Basics and mounting

Wiring 8x periphery modules

Clack
2.6 Wiring 8x periphery modules
Terminal module terminals
22
4. For mounting turn the locking lever of the module upwards until it engages.
5. For mounting place the module to the module installed before and push the module
to the mounting rail guided by the strips at the upper and lower side of the module.
6. Turn the locking lever of the periphery module downward, again.
7. After mounting the whole system, to protect the backplane bus connectors at the
last module you have to mount the bus cover, now. If the last module is a clamp
module, for adaptation the upper part of the bus cover is to be removed.
CAUTION!
Do not connect hazardous voltages!
If this is not explicitly stated in the corresponding module description,
hazardous voltages are not allowed to be connected to the corresponding
terminal module!
With wiring the terminal modules, terminals with spring clamp technology are used for
wiring. The spring clamp technology allows quick and easy connection of your signal and
supply lines. In contrast to screw terminal connections this type of connection is vibration
proof.
VIPA System SLIO
HB300 | FM | 050-1BS00 | en | 20-40