Table of Contents
Advertisement
Switching on the Water Filter Display
If the
Water Filter Display
switched off once, it must be switched
on again if required.
In Settings mode , use the and
sensor controls to select the
Filter Display
and select OK to confirm
your selection.
Use the and sensor controls to
select
On
and select OK to confirm
your selection.
The
Water Filter Display
switched on.
Switching off the Water Filter Display
Risk to health due to contami-
nated water.
If the IntensiveClear 2.0 charcoal fil-
ter is not replaced on a regular basis,
it may become contaminated.
Only switch off the
if an external water filter has been at-
tached to your household water sup-
ply in place of the IntensiveClear 2.0
charcoal filter. In this case, you
should also use an IntensiveClear 2.0
mesh filter in place of the Intensive-
Clear 2.0 charcoal filter (see "Acces-
sories – Optional accessories").
In Settings mode , use the and
sensor controls to select the
and select OK to confirm
Filter Display
your selection.
Use the and sensor controls to
select
Off
and select OK to confirm
your selection.
has been
Water
has been
Water Filter Display
Water
Selecting additional settings
The
Water Filter Display
switched off.
Resetting the Water Filter Display
After you have replaced or cleaned the
water filter, you must reset the
so that it can be displayed
ter Display
again after 6 months.
If you do not reset the display, it ap-
pears again and again.
In Settings mode , use the and
sensor controls to select the
Filter Display
and select OK to confirm
your selection.
Use the and sensor controls to
select
Reset
your selection.
The
Replace the water filter
appears from the display.
The
Water Filter Display
vated for the next time the water filter
requires cleaning or replacing.
has been
Water Fil-
and select OK to confirm
message dis-
has been acti-
Water
75
Advertisement
Table of Contents
